JUVTMALL

we also supply for PCB prototyping and PCBA servies,
for more information please click: www.juvtmall.com

评论

发表评论

此博客中的热门博文

About PCB and PCBA

图片
PCB and PCBA A PCB (Printed Circuit Board) is a board that electrically connects electronic components using conductive traces, pads, and other features etched from copper foil laminated onto a non-conductive substrate. PCB’s can be  single sided  (one copper layer),  double sided  (two copper layers), or  multi-layer  (outer and inner layers). Conductors on different layers are connected with vias (plated-thru. holes). Multi-layer PCB’s allow for much higher component density and design complexity. PCBA (Printed Circuit Board Assembly) is the board obtained after all printing solder paste on the PCB and then mounting various components like resistors, ICs (Integrated Circuits), capacitors and any other components  like transformers depending on the application and desired characteristics of the board. A PCBA usually undergoes reflow furnace heating to establish a mechanical connection between the PCB and the components.
阅读全文

10. The design of PCB (multiple layer board)--Basic requirement of designing multiple layer PCB VOL2

图片
The requirements of wire cloth and wiring   Juvtmall  ( a company supply  PCB Prototyping ,  PCBA service  and sell kinds of  components, modules  and so on)  In general, PCB multilayer board wiring is performed according to circuit function. In outer wiring, it is required to have a lot of wiring in the welding surface, and the components are less wiring, which is beneficial to the maintenance and platoon of printing plate. Thin, tight conductor and easily disturbed signal lines, usually arranged in the inner layer. The large area of copper foil should be evenly distributed in the outer layer, which will help to reduce the warping of the plate and make the plating more uniform on the surface. In order to prevent the short circuit between the surface and the printed wire and the mechanical processing, the distance of the conductive graph in the inner and outer layers should be greater than 50mil. Wire direction and line widt...
阅读全文

5. The design of PCB--design considerations and assembly rules

图片
. PCB design considerations   Juvtmall  ( a company supply  PCB Prototyping ,  PCBA service  and sell kinds of  components, modules  and so on)  (1) avoid setting important signal lines on the edge of PCB, such as clock and reset signal. (2) the distance between the ground wire of the enclosure and the signal line is at least 4mm; keep the length and width of the ground wire to be less than 5:1 to reduce the inductance effect. (3) lock the device and line that identified location with LOCK function, so that they will not be misused. (4) the width of the conductor should not be less than 0.2mm (8mil). In high-density and high-precision printed circuit, the width and spacing of the wires are generally preferable to 12mil. (5) Routing in the IC pin of DIP package, 10-10 and 12-12 principles can be applied, as between the two pins by 2 lines, diameter of bonding pad  can be set to 50 mil, width and spacing of line is 10 mil, when o...
阅读全文