xiao

2.  Method of wiring on multiple layers PCB       Juvtmall  ( a company supply  PCB Prototyping ,  PCBA service  and sell kinds of  components, modules  and so on)     Generally, four layers board can be divide into top layer, bottom layer and two internal layer. Internal layer: by command “DESIGN/LAYER STACK MANAGER” use “ADD PLANE” add “INTERNAL PLANE1” and “INTERNAL PLANE2” as VCC and GND in power and GND layer (tip: don’t use “ADD LAYER”, it will add MIDPLAYER, it’s used in multiple layer of signal track), if there are several power layer such as VCC2 or GND layer such as GND2, then use bolder wire or FILL to draw a district on power of GND belongs to PLANE1 or PLANE2,  use PLACE/SPLIT PLANE to make a corresponding district (VCC2 copper and GND2 copper flakes are not present in this area in the same PLANE) tip: different surface layers in the same PLANE and try not to overlap.SPLIT1 and SPLIT2 are overlappe...

9. PCB design related skills   Juvtmall  ( a company supply  PCB Prototyping ,  PCBA service  and sell kinds of  components, modules  and so on)  PCB design setting technique The PCB design needs to be set different points  in different stages. In the layout phase, the device layout can be used in the large lattice point . For large devices such as IC and non-locating connectors, the lattice site of 50~100mil can be selected for layout, and the grid point of 25mil can be used for the distribution of passive devices such as resistance capacitance and inductance. The precision of the large lattice point is beneficial to the orderliness and beauty of components. PCB layout rules 1. In general , all components shall be decorated on the same side of the boards, only the top-level element too close, set some highly limited and calorific value small devices o n the bottom., such as SMD resistor, SMD capacitors, SMD IC, etc. 2....